Proposed amendments to the proposed revisions to the 1958 Agreement pursuant to the international whole vehicle type approval project.

Clarification to affirm CLEPA’s understanding that the proposed new numbering system applies only to the numbering of type approval certificates and not to the approval mark to be put on each approved components.

Proposal to transfer brake assist systems provisions out of UN Regulation 13-H and into a new stand-alone regulation. The proposal arises from a perceived need to simplify UN R13-H to facilitate its application within the proposed international whole vehicle type approval.

Proposal to delete references to electronic control systems and brake assist systems within UN R13-H in order to simplify use of the regulation within the proposed international whole vehicle type approval regulation. These provisions would be taken up by new separate UN Regulations.

Proposal to transfer electronic stability control systems provisions out of UN Regulation 13-H and into a new stand-alone regulation. The proposal arises from a perceived need to simplify UN R13-H to facilitate its application within the proposed international whole vehicle type approval.

Discussion paper concerning the approval markings that might be used under the international whole vehicle type approval system in association with approval codes, numbers, or markings required by individual UN Regulations.

Proposal to transfer electronic stability control systems provisions out of UN Regulation 13-H and into a new stand-alone regulation. The proposal arises from a perceived need to simplify UN R13-H to facilitate its application within the proposed international whole vehicle type approval. This document supersedes document GRRF-75-15.

Proposal for amendments to delete provisions for electronic stability and brake-assist systems from UN R13-H as part of their transposition into new stand-alone regulations.

Proposal to transfer brake assist system systems provisions out of UN Regulation 13-H and into a new stand-alone regulation. The proposal arises from a perceived need to simplify UN R13-H to facilitate its application within the proposed international whole vehicle type approval. This document supersedes document GRRF-75-14.

Proposal to specify that safety aspects of ESC systems can be assessed under this new regulation or under UN R13-H. The objective of the proposed wording is to avoid redundant certification of the complex electronic control systems (CEL) aspects of ESC according to both the proposed ESC regulation and UN Regulation No. 13-H (keeping unchanged the level of safety). The proposal would permit the applicant to show evidence that CEL compliance has already been achieved according to Annex 8 of UN Regulation No. 13-H as an alternative to demonstrating compliance with the CEL annex of the ESC regulation.

Proposal to specify that safety aspects of brake assist systems can be assessed under this new regulation or under UN R13-H. The objective of the proposed wording is to avoid redundant certification of the complex electronic control systems (CEL) aspects of ESC according to both the proposed BAS regulation and UN Regulation No. 13-H (keeping unchanged the level of safety). The proposal would permit the applicant to show evidence that CEL compliance has already been achieved according to Annex 8 of UN Regulation No. 13-H as an alternative to demonstrating compliance with the CEL annex of the BAS regulation.

Proposed amendments to UN R13-H to confirm that the complex electronic control system (CEL) requirements may be satisfied through an approval conducted under another regulation (e.g., the pending new ESC and BAS regulations) and to delete the marking requirement concerning ESC systems which will no longer be within the scope of UN R13-H.

Proposal to amend the draft text for the proposed new regulation on BAS which would extract the BAS provisions from the current UN R13-H on light vehicle braking systems. The intention is to clarify the meaning of the text in places where it is ambiguous when taken out of the context of UN R13-H.