Draft for consideration for the electric vehicle safety GTR.

Update by the IEC of the German proposal for revisions to IEC 60809 and 60810 in accordance with UN Regulations for signalling devices to address risks in the use of low-quality non-replaceable filament lamps.

Submission by the International Electrotechnical Commission (IEC) to clarify provisions in UN R37: Revision 6, to amend data in draft Supplement 39 (WP.29/2012/09) and to correct data in the proposal by GTB document GRE/2012/02.

Updates to UN R99 tables concerning certain references to International Electrotechnical Commission (IEC) publications. The text is based upon UN R99 up to and including draft Supplement 7 (document WP.29/2011/101).

IEC has serious concerns with the proposal to clarify the conditions under which voltage control gear may be used in conjunction with filament light sources because halogen filament light sources should not be operated permanently outside the specifications, at a too low or at too high voltage.

IEC response to the GTB proposal to define the conditions under which voltage control gear may be used in conjunction with filament light sources.

Update by the IEC of the German proposal for revisions to align IEC 60809 and 60810 with UN Regulations for signalling devices to address risks in the use of low-quality non-replaceable filament lamps.

Submission from the International Electrotechnical Commission (IEC) to correct the omission of the letter “q” from the cap designation of category PR27/7W in Regulation No. 37.

This is a generic proposal to require approval according to a light source
regulation prior to an application for approval under UN R10. It appears that LED retrofit light sources are offered to the market with Regulation No. 10 approval only where they should also be subject to the new UN R127.

Text prepared by the International Electrotechnical Commission (IEC) in order to amend data in draft Supplement 40 (WP.29/2012/70) and draft Supplement 41 (WP.29/2013/17).

Comments from IEC on the informal document GRE-69-15/Rev.1 (“Priority of Discussion on Technical Requirements for IWVTA and Draft Report to IWVTA Informal Meeting”)

Proposal to clarify and reinsert provisions concerning the approval of electronic/electrical subassemblies related to lighting devices within the proposal to extend the scope of UN R10 to all power train systems above a certain working voltage level when they are in charging mode and and including type approval of separate electrical components for the “REESS charging mode coupled to power grid” configuration.

[Note: Document GRE/2013/41 has been superseded by document GRE-70-14.]

Proposal to improve the clarifications proposed regarding the requirements to avoid intentional non-approved (voltage) variation of the principal passing beam, using halogen light sources and to harmonize them with the operating voltage requirements in UN Regulation No. 48

Proposal to insert the IEC cap sheet numbers assigned for the new light categories WT21W, WTY21W, WT21/7W and WTY21/7W.

Proposal to insert the IEC cap sheet number for the new light category LW2 into the regulation.

Document GRE/2013/62 concerning electronic light source control gear proposed to introduce requirements to avoid intentional non-approved (voltage) variation of the principal passing beam using halogen light sources and to harmonize them with the operating voltage requirements in UN Regulation No. 48. The objective of this proposal is to restrict the voltage at headlamps equipped with (halogen) filament lamp light sources in order to avoid excessively high or low (semi-) permanent luminous intensity of the headlamp and consequently shorter lifetime of the halogen light source. This submission takes into account the positions presented in documents GRE/2013/44, GRE/2013/62, GRE-70-17, and GRE-70-34.

Documents GRE/2014/20, GRE/2014/24 and GRE/2014/29 propose to add light categories to UN Regulation Nos. 37, 99, and 128; however, since the amendment or extension of an IEC60061 cap sheet results in a change to the sequence number of the sheet, all light source category sheets that refer to that IEC sheet need an update. Therefore, the IEC proposes the necessary changes to the text of the above proposals.

Document GRE/2014/31 proposes to introduce requirements to avoid intentional non-approved (voltage) variation of the passing and driving beam, using halogen light sources and to harmonize it with the operating voltage requirements in Regulation No. 48. This correction seeks to improve the text by replacing the “about value” for the reference luminous flux with the exact value of 13.2V and to simplify the C.o.P. procedure.

Proposal to correct HIR2 headlamp data.

Illustration of interlock solutions for the categories C5W/LEDK, W5W/LEDK and WY5W/LED proposed in the documents GRE/2019/9 and GRE/2019/10.

IEC support for the for choosing elevated ambient air temperature of 60°C and luminous flux limit of at least 70% at the points where luminous flux is measured. GRE/2019/21 Proposal for amendment to the Consolidated Resolution on the common specification of light source categories: the aim to introduce a new light emitting diode (LED) substitute light source category H11/LED for road illumination applications

A general reference to the definitions in R.E.5 is inserted in 2.1 and a specific reference to the definition of the “AE device” in R.E.5 is inserted in 2.2.2.2.2.b., in order to explain the term “AE device” where it first appears in the body text.

Proposal for updating the reference to IEC 60809 in GRE/2021/13 (R148.01) and GRE/2021/14 (R149.01)

Discussion of UN approval process versus national approval processes with request for guidance.

Proposal to update the reference to IEC Publication 60809.

Proposal to introduce requirements to avoid intentional non-approved (voltage) variation of the passing and driving beam, using halogen light sources and to harmonize it with the operating voltage requirements in Regulation No. 48.

Proposal to align the approval code for light sources approved according to Regulations Nos. 37, 99 and 128, with the approval number as prescribed by Revision 3 of the 1958 Agreement, schedule 4.

Comments on the proposed mandate for the SLR informal group.

Proposal for a resolution to simplify the content and procedures of the light source regulations (UN Regulations Nos. 37, 99, and 128)..