roposal to expand the application of glare-free Adaptive Driving Beam (ADB) for category L₃ motorcycles under UN R149, by introducing additional driving beam classes aligned with UN R53 motorcycle requirements and adding symmetrical passing beam-based photometric requirements below the H-H line (Table 13, Part C). Recent technological advances have made ADB electronics more practical for a broader range of motorcycles, and these amendments aim to enhance traffic safety by reducing glare while maintaining adequate rider visibility.

Proposal to introduce a clarification of grouped markings and labels. Further details can be found in informal document GRE-94-07.

Proposal to clarify the 80% failure criterion for Conformity of Production (CoP) checks by confirming that CoP tables represent a simplified subset of the full Class C type-approval measurement points, and to exclude overhead requirements (items S50 and S100 in Tables 6 and 7) from the passing beam failure detection criterion, as these may be fulfilled by position lamps. Further details can be found in informal document GRE-94-08.

Proposal to improve the clarity and structure of Conformity of Production (CoP) requirements for driving beams in UN R149 by following the approach used in UN R123.

Proposal to correct inconsistencies and calculation errors in Conformity of Production (CoP) tables across both series of UN R149, which may otherwise cause confusion for manufacturers and technical services.

In UN R149-00, corrections include: deletion of erroneous maximum values at point 50L in CoP tables for Classes C, V and W Bend Light; correction of miscalculated 20% and 30% CoP minimum values for Classes C and V Bend Light Category 1; correction of the Class W non-bending mode maximum value at Segment 10 and its derived CoP values; and correction of rounding errors in Class R CoP minimum values.

In UN R149-01, corrections include: updating the Class W Bend Light CoP maximum at point BR to align with the type-approval table; correcting miscalculated Class R Bend Lighting CoP values; and fixing table note references in Annex 4 following the introduction of scientific notation in the 01 series.

Further details can be found in informal document GRE-94-10.

Proposal to amends requirements for LED light source modules and non-replaceable light sources. Amendments specify headlamp and AFS technical specifications including light source module characteristics, electrical interfaces, and photometric values. Requirements for LED light source modules and non-replaceable light sources address design, manufacture, testing conditions, colour rendering, UV-radiation, and objective luminous flux measurement procedures.