The agenda and minutes from the 51st session were adopted without comment. The group discussed a status report on Supplement 3 to UN R10.07, updated Terms of Reference, and proposals for the 08 series of amendments, with decision to move submission to 2027/2028 to integrate test modes for automated driving systems. The group reviewed proposals on steer-by-wire systems, CISPR average detector clarification, flicker requirements, and AC/DC charger specifications, concluding that most require further elaboration or revision. The 53rd meeting is scheduled for 1–2 July 2026 in Paris.

The EMC informal group proposes to hold a meeting in Tokyo during the 2nd or 4th week of November 2027, with demonstration venue also in Tokyo. Proposed demonstration content is to be determined for automated driving systems. The meeting contents are subject to change.

Proposal to clarify ADS Active Mode, clarify methods to activate ADS using test equipment or by modifying in-vehicle ADS-related ECU software, clarify test objects for ESA at component-level or system-level, and clarify test methods when ADS cannot be activated in an anechoic chamber, when testing in a non-active state, or when errors occur upon ADS activation. This preliminary proposal is intended for presentation at IWG EMC meetings in autumn 2026.

Proposal regarding methods for evaluating electromagnetic immunity of blind-spot detection systems. The proposal identifies this as a subject for discussion as part of ADAS evaluation methods. The form requests consideration of revisions to evaluation methods, with reference to presentation materials. The proposal’s disposition status remains to be determined by the IWG.

Methods for evaluating electromagnetic immunity of blind-spot detection systems are proposed using a simple reciprocating motion device equipped with a reflector. The electromagnetic immunity test is conducted after the BSD system has been activated. Vehicle’s electromagnetic immunity test methods and conditions are consistent with the previous ones. Reproducibility has been verified across various vehicle models with only minor adjustments required. The proposal seeks opinions from member countries regarding the necessity of electromagnetic immunity evaluation methods for BSD systems.

OICA proposes that Roadmap Items 2, 2bis, 3, and 4 be withdrawn or deferred until relevant international standardization bodies publish validated methodologies. OICA opposes radiated emissions requirements below 30 MHz in driving and charging modes, radiated emissions in the 16 GHz range, and variable driving conditions assessments, citing lack of technical rationale, absence of published international standards, poor reproducibility for large vehicle categories M₃ and N₃, and inconsistency with WP.29/2024/39 reproducibility standards. New R10.08 work items must demonstrably enhance safety, align with published international standards, and maintain regulatory stability per ECE/TRANS/WP.29/1044/Rev.3 and WP.29-196-07, WP.29-196-26, and ECE/TRANS/WP.29/1182.

Proposal to address REESS using offboard AC/DC chargers. Some vehicles with REESS use offboard AC/DC chargers, a configuration not described in UN R10. The proposal adds test configurations for vehicles charging through offboard AC/DC chargers to multiple annexes, including flowcharts defining charging mode configurations and specifications for AMN or DC-charging-AN or AN for offboard AC/DC chargers below 60 Vdc. The proposal is based on IWG-EMC-49-12e.

Proposal to establish items for the 08 series of UN R10: address immunity-related functions required by multiple UN Regulations through discussion of whether to include these features in UN R10 or relocate electromagnetic compatibility provisions to individual UN Regulations; amend test procedures for complex systems including steer-by-wire, brake-by-wire, and ADAS features to establish clear protocols and reduce unlevel playing field items; improve the general approval process through precise vehicle type description and definition of high-level objectives; describe dwell time selection through ISO standard 1154 as minimum; discuss ISO 17025 evaluation principles; discuss antenna position at 3m versus 10m for best-case and worst-case scenarios; and require robust electromagnetic compatibility protection with critical details described in test reports and information documents.

Proposal to add radiated emission testing requirements in the frequency range 1 GHz to 6 GHz. New clause 6.2.2.5 specifies limits for vehicle measurements at 3.0 ± 0.05 m antenna distance using peak and average detectors, with limits of 70/50 dB(V/m) for 1000–3000 MHz and 74/54 dB(V/m) for 3000–6000 MHz. New Annex XY describes test methods using IEC 61000-6-3 Ed.4.0 and CISPR 12 provisions. New clause 6.5.3 establishes ESA broadband type approval limits with higher thresholds. New Annex XZ prescribes ESA measurement methods, including test arrangements for REESS charging mode coupled to the power grid.

The IWG-EMC 52nd meeting is scheduled for 7 May 2026 as a web conference. The agenda includes feedback from the GRE 94th session regarding Supplement 3 to UN R10.07 and discussion of the roadmap for 08 series of amendments with proposals from Contracting Parties and non-governmental organizations. The session will address GRE-94-56-Rev.2 and documents covering topics such as harmonics limits, charging conditions, immunity requirements, and radiated requirements. The next meeting is scheduled for 1–2 July 2026 in Paris.

OICA opposes inclusion of four roadmap items in UN R10.08 amendments based on WP.29 principles for evidence-based rulemaking. Items 2 and 2bis (radiated emissions below 30 MHz) fail reproducibility standards, lack validated test methods for all vehicle categories, and rely on standards not applicable to internal combustion engine vehicles. Item 3 (16 GHz range) violates the requirement for specific standard versions as CISPR 12 lacks finalized methodology. Item 4 (variable driving conditions and 4-side antenna assessment) presents measurement reproducibility concerns. OICA recommends deferral pending publication of validated international standards.

The IWG-EMC 51st session (March 2026) addressed the roadmap for UN R10.08 amendments and proposals. Key discussion items included transitional provisions for UN R10.07, artificial network corrections for Supplement 3, harmonics and flicker requirements, radiated emissions aligned with CISPR standards, and extensive work on automated driving system (ADS) fitness requirements. The group extensively debated ADS test configurations, immunity and emissions testing, laboratory capabilities, and steering system requirements. Multiple proposals—including IWG-EMC-51-04, IWG-EMC-51-06, and IWG-EMC-51-07 on harmonics and flicker—were discussed. The session concluded with plans to submit ADS fitness proposals and artificial network corrections as Supplement 3 of UN R10.07 to GRE, with next meetings scheduled for May and July.

Proposal to update Terms of Reference for the Informal Working Group on Electromagnetic Compatibility. Items 21 and 22 add timelines for the 08 series of amendments of UN Regulation No. 10: an informal document for the 95th session of GRE in October 2026, and a formal document for the 96th session in April 2027, with final submission by end of January 2027, for adoption in WP.29 in November 2028.

Proposal to insert new paragraphs 0 through 0.1.2, amend paragraphs 1.1, 1.3, and 2.12, insert new paragraphs 2.9.4 and 2.32, delete paragraphs 2.26 and 2.27, insert new paragraph 3.1.9, insert new paragraph 6.11 with sub-paragraphs, amend paragraph 9.3.2, and amend Figures 3, 4, 5, and 6 in Appendix 8, and add items 74 and 75 to Annex 2A, insert paragraph 7 in Annex 3A, and amend Annex 4, Annex 5, Annex 6, and related sections to accommodate ADS vehicles, including categories X and Y.

Proposal to amend UN Regulation No. 10 (Electromagnetic Compatibility) through a Supplement to the 07 series of amendments to fit Automated Driving System requirements. The proposal introduces new paragraphs defining ADS and ADS test configuration; amends paragraph 1.3 to include ADS control; expands paragraph 2.12 on immunity-related functions to cover ADS sensor performance; deletes paragraphs 2.26 and 2.27; adds paragraph 6.11.3 on special ADS requirements; and introduces an “Active ADS Mode” test table in Annex 6 paragraph 2.1.1.2, establishing test conditions for vehicles with active ADS features performing the Dynamic Driving Task.

Proposal to insert new paragraph 5.3. into UN R178 (Emergency Lane Keeping Systems). The new paragraph requires that the effectiveness of ELKS shall not be adversely affected by magnetic or electrical fields, demonstrated by fulfilling technical requirements and respecting transitional provisions of the 06 or any subsequent series of amendments to UN R10. This proposal aims to ensure Electromagnetic Compatibility and make the reference future proof for potential ELKS requirements in future series of amendments to UN R10, based on GRVA-24-05/Rev.2.

The document discusses transitional provisions for UN R10.07 series amendments, which entered into force June 2025. Contracting Parties shall not refuse type approvals under the 07 series amendments. As from 1 September 2029, Contracting Parties need not accept type approvals under preceding series first issued after that date, but shall continue accepting those first issued before that date for vehicles, vehicle systems, equipment, and parts not affected by changes introduced by the 07 series amendments. The document references ECE/TRANS/WP.29/1044 rev3 for general transitional provision guidance. Nearly all vehicles and ESAs will not be granted extensions for UN R10.06 after 1 September 2029, except those complying only with broadband emissions.