Proposal as approved by the GRE to correct an error introduced by Supplement 21 to the 02 series of Regulation No. 7 (document WP29/2012/65). Supplement 21 introduced provisions for the use of light-emitting diode (LED) light sources and corrected the provisions concerning approval markings.

Revision of the regulation on position lamps pursuant to the proposal to simplify the UN lighting regulations.

Example of what Regulation No. 7 might look like under the simplification of lighting regulations through the use of a “horizontal reference document” that would consolidate provisions common across lighting regulations.

Proposal to correct an error introduced by Supplement 21 to the 02 series of Regulation No. 7 (document WP29/2012/65). Supplement 21 introduced provisions for the use of light-emitting diode (LED) light sources and corrected the provisions concerning approval markings.

Document prepared by the Secretariat in order to inform GRE about complaints, which do not seem to be isolated, concerning the intensity of LED brake lights in non-emergency braking situations.

Proposal to reference the compliance requirements for installation contained in Regulations Nos. 48, 53, 72 and 86 into the Regulations 3, 4, 6, 7, 19, 23, 38, 50, 77, 87, 91, 98, 104, 112, 113, 119 and 123. This proposal is a revised version of document GRE/2013/55 discussed during the October 2013 GRE session.

The text reproduced below was prepared by the expert from the International Automotive Lighting and Light Signalling Expert Group (GTB) to amend the requirements to clarify the “n-1 rule” provisions in relation to an interdependent lamp system. This document has been withdrawn from consideration.

Text prepared by the International Automotive Lighting and Light Signalling Expert Group (GTB) to clarify the definition of “type”, with regard to manufacturer, trade names and marks and to introduce editorial improvements to the requirements for markings.

Although documents GRE/2013/45 and GRE-70-02 were adopted by GRE at its last (70th) session, this proposal consolidates the amendments and offers editorial improvements to the provisions concerning markings in Regulations Nos. 19, 23, 38, 65 and 119. These editorial improvements aim to clarify that the devices, and not only the samples, shall bear the trade name or mark and align the requirements with the other correctly worded regulations to avoid misunderstanding.