GRPE/2017/3
Proposal for a new GTR on evaporative emissions test procedures under the Worldwide harmonized Light vehicles Test Procedure (WLTP EVAP)
Proposal for a new GTR on evaporative emissions test procedures under the Worldwide harmonized Light vehicles Test Procedure (WLTP EVAP)
|
Reference Number: GRPE/2017/3
|
Text prepared by the Evaporative emissions Task Force of the WLTP informal working group in line with Phase 2 of its mandate (ECE/TRANS/WP.29/AC.3/44). The WLTP referred to a first draft of this proposal (GRPE-73-12) at the seventy-third session of GRPE (see report ECE/TRANS/WP.29/GRPE/73, para. 12).
|
Document date: 25 Oct 16
|
Document status: Superseded
|
Relevant to
|
View full document file for more information
|
GRPE/2017/7
Proposal for Amendment 2 to global technical regulation No. 15
Proposal for Amendment 2 to global technical regulation No. 15
|
Reference Number: GRPE/2017/7
|
Amended Phase 2a Worldwide Light vehicles emissions Test Procedure (WLTP). Versions of the amended GTR highlighting the changes to the original regulation are available in word format and pdf format. The amendments address: - If an alternative value is applied for a parameter, such as a higher n_min_drive or an ASM, this parameter value has to be the same within an interpolation family (Paragraph 5.6.1.).
- The mass in running order used for the calculation of the power to mass ratio is replaced by mass in running order minus 75 kg (paragraph 1. of Annex 1).
- Idle engine speed n_idle is removed from the power curve measurement requirement (paragraph 2. of Annex 2).
- The additional safety margin (ASM) value may be decided by manufacturer rather than the prescribed exponential curve (paragraph 3.4. of Annex 4).
- The number of decimal place of road load coefficients is defined (paragraph 2.4. of Annex 4).
- Additional restrictions are set to the application of the split run method for coastdown testing (paragraph 4.3.1.3.4. of Annex 4).
- Specific data rejection criteria are added (paragraph 4.3.1.4.3. of Annex 4).
- The “delta method” for road load determination is added (paragraph 6.8. of Annex 4 and other paragraphs. See section 4.4.25.for more detail).
- The roller radius correction factor is modified(paragraph 6.6.3. of Annex 4).
- The allowable combination of the test vehicle selection and family requirements are further clarified (paragraph 4.2.1.3. of Annex 4 and other paragraphs of Annex 4).
- Provisions for an additional cooling fan are included(paragraph 1.1.5. and 1.1.6. of Annex 5).
- The correction of measurement/recording frequency requirements are specified (over several annexes).
- Calculation of the n/v ratio is defined (paragraph 8. of Annex 7).
- The stepwise procedure for calculating the final test results of OVC-HEVs is added (paragraph 4.6. of Annex 8).
|
Document date: 28 Oct 16
|
Document status: Superseded
|
Relevant to
|
View full document file for more information
|
GRPE-74-02/Rev.1
Proposal for amendments to ECE/TRANS/WP.29/GRPE/2017/7 (Amendment 2 to GTR No. 15)
Proposal for amendments to ECE/TRANS/WP.29/GRPE/2017/7 (Amendment 2 to GTR No. 15)
|
Reference Number: GRPE-74-02/Rev.1
|
WLTP informal working group refinements to the amendment proposal.
|
Document date: 12 Jan 17
|
Relevant to
|
View full document file for more information
|
GRPE-74-03/Rev.1
Consolidated revision of GTR No. 15 incorporating Amendment 2
Consolidated revision of GTR No. 15 incorporating Amendment 2
|
Reference Number: GRPE-74-03/Rev.1
|
Complete version of GTR No. 15 including the proposed Amendment 2 (GRPE/2017/7) and latest refinements by the WLTP informal group (GRPE-74-02). Amendment 2 corresponds to phase 2a development of the GTR, including the following modification to the text: - If an alternative value is applied for a parameter, such as a higher n_min_drive or an ASM, this parameter value has to be the same within an interpolation family (Paragraph 5.6.1.).
- The mass in running order used for the calculation of the power to mass ratio is replaced by mass in running order minus 75 kg (paragraph 1. of Annex 1).
- Idle engine speed n_idle is removed from the power curve measurement requirement (paragraph 2. of Annex 2).
- The additional safety margin (ASM) value may be decided by manufacturer rather than the prescribed exponential curve (paragraph 3.4. of Annex 4).
- The number of decimal place of road load coefficients is defined (paragraph 2.4. of Annex 4).
- Additional restrictions are set to the application of the split run method for coastdown testing (paragraph 4.3.1.3.4. of Annex 4).
- Specific data rejection criteria are added (paragraph 4.3.1.4.3. of Annex 4).
- The “delta method” for road load determination is added (paragraph 6.8. of Annex 4 and other paragraphs. See section 4.4.25.for more detail).
- The roller radius correction factor is modified(paragraph 6.6.3. of Annex 4).
- The allowable combination of the test vehicle selection and family requirements are further clarified (paragraph 4.2.1.3. of Annex 4 and other paragraphs of Annex 4).
- Provisions for an additional cooling fan are included(paragraph 1.1.5. and 1.1.6. of Annex 5).
- The correction of measurement/recording frequency requirements are specified (over several annexes).
- Calculation of the n/v ratio is defined (paragraph 8. of Annex 7).
- The stepwise procedure for calculating the final test results of OVC-HEVs is added (paragraph 4.6. of Annex 8).
|
Document date: 12 Jan 17
|
Document status: Superseded
|
Relevant to
|
View full document file for more information
|
GRPE-74-04
Draft technical report on the development of a new global technical regulation on Evaporative emission test procedure for the Worldwide harmonized Light vehicles Test Procedure (WLTP EVAP)
Draft technical report on the development of a new global technical regulation on Evaporative emission test procedure for the Worldwide harmonized Light vehicles Test Procedure (WLTP EVAP)
|
Reference Number: GRPE-74-04
|
Document date: 04 Jan 17
|
Relevant to
|
View full document file for more information
|
GRPE-74-05
Technical report on the development of global technical regulation No. 15 on WLTP including Amendment 2
Technical report on the development of global technical regulation No. 15 on WLTP including Amendment 2
|
Reference Number: GRPE-74-05
|
Official technical report detailing the rationale and decision-making behind the development of Amendment 2 (Development Phase 2a) of GTR No. 15.
|
Document date: 04 Jan 17
|
Document status: Superseded
|
Relevant to
|
View full document file for more information
|
GRPE-74-10
Highlights related to ECE/TRANS/WP.29/GRPE/2017/3 on WLTP EVAP
Highlights related to ECE/TRANS/WP.29/GRPE/2017/3 on WLTP EVAP
|
Reference Number: GRPE-74-10
|
Pursuant to the development of a GTR on evaporative emissions under the WLTP informal group, ETRMA presents its views on the draft procedure in order to clarify the role of tyres.
|
Submitted by: ETRMA
|
Document date: 11 Jan 17
|
Relevant to
|
View full document file for more information
|
GRPE-74-20
Transposition of GTR 15 (WLTP) into UN Regulations under the 1958 Agreement
Transposition of GTR 15 (WLTP) into UN Regulations under the 1958 Agreement
|
Reference Number: GRPE-74-20
|
European Commission report on the effort to transpose the GTR on light vehicle emissions into UN type approval regulations, including handling of current UN Regulations on emissions (notably, UN R83 and UN R101) and process for implementing the WLTP requirements.
|
Submitted by: EC
|
Document date: 12 Jan 17
|
Relevant to
|
View full document file for more information
|
GRPE-74-11
Status report of the WLTP informal group
GRPE-72-18
Transposition of GTR No. 15 WLTP into EU Regulations and UN/ECE Regulations
GRPE-73-26
Comments on the transposition process of GTR No. 15 (WLTP) into UN Regulation (1958 Agreement)
GRPE-74-16
Proposal for amendments to ECE/TRANS/WP.29/2017/42, ECE/TRANS/WP.29/2017/43 and ECE/TRANS/WP.29/2017/44
Proposal for amendments to ECE/TRANS/WP.29/2017/42, ECE/TRANS/WP.29/2017/43 and ECE/TRANS/WP.29/2017/44
|
Reference Number: GRPE-74-16
|
The subject documents would permit Contracting Parties applying UN R83 and/or UN R101 and which have transposed GTR No. 15 (WLTP) into their local legislation to refuse to accept type approvals granted under the UN R83 and/or UN R101 as a compliance alternative to their national/regional legislation (i.e., aligned with GTR No. 15). OICA proposes to clarify the intent by deleting allusions to the measure as a form of derogation, to replace the phrase “may no longer accept” with “may refuse”, and to introduce a sunset clause to noting that the measure is intended as a stop-gap until such time as GTR No. 15 has been transposed into the corpus of UN Regulations.
|
Submitted by: OICA
|
Document date: 11 Jan 17
|
Document status: Not supported
|
Relevant to
|
View full document file for more information
|