Proposal pursuant to discussions at the 55th GRSP session to revise an initial German proposal to reduce the risk of a person being unintentionally locked inside a vehicle by an anti-theft system. This proposal would either prohibit systems that could lock an occupant inside a vehicle (by requiring an occupant detection capability) or require warning systems (such as a horn) that can be activated from inside the vehicle even when it is fully locked.

Proposal to remove the specification of “±0.01 m/sec” for the accuracy of the velocity measurement in Annex 5, Paragraph 3.2.1. This would leave in place the specification to use the measurement procedure if ISO 3784:1976 which specifies an accuracy of ±1 %.

OICA presentation arguing for chest deflection threshold of 42 mm for the 5th Female H-III dummy.

Proposal to require that a horn or other acoustic signalling system can be activated from within a parked vehicle when in the fully locked mode and to set the transition period through 1 September 2016 for meeting the new requirement.

Draft text for the transposition of GTR No. 13 on hydrogen and fuel-cell vehicle safety into a new UN Regulation under the 1958 Agreement. This version incorporates comments received by GRSP at its 55th session and informal document GRSP-55-23 from the expert of Rep. of Korea.

Proposal for a new UN Regulation transposing the requirements of the UN Global Technical Regulation on pole side impact (GTR No. 14). This proposal is accompanied by a proposal for a 01 series of amendments (documentGRSP/2014/12) that would enable Contracting Parties applying this Regulation to require a vehicle-to-pole impact speed of 32 ± 1 km/h regardless of the “vehicle width”. This proposal supersedes the earlier version presented in document GRSP/2014/9.

Proposal as revised during the 55th GRSP session (superseding document GRSP/2014/06) incorporating changes to UN R94 in light of the development of the new regulation concerning protection in frontal collisions with focus on the restraint system, especially to improve the protection of older occupants.

Proposal by the secretariat to correct a reference to UN R25 to refer to the 04 series of amendments rather than to the 03 series of amendments.

Explanatory document on the deliberations and outstanding issues concerning the draft UN Regulation and its proposed 01 series of amendments. These issues concern the references to an ISO standard and transitional provisions for the amendment.

Proposal for an 01 series of amendments to the proposed new UN Regulation on pole side-impact protection (transposing GTR No. 14). This proposal would permit contracting parties to to require a vehicle-to-pole impact speed of 32 ± 1 km/h regardless of the “vehicle width” and is based upon document GRSP/2014/12 and amends the draft PSI regulation as proposed in document WP.29/163/14. The Working Party on Passive Safety approved this proposal provided that Australia would seek guidance on its transitional provisions (since this amendment would, in principle, be adopted at the same time as the original PSI regulation at the November 2014 WP.29 session). This draft incorporates comments from Germany, Japan, and OICA received after the GRSP 55th session.

Draft proposal transposing the provisions of the pole side-impact protection Global Technical Regulation into a UN Regulation as approved by the Working Party on Passive Safety (document GRSP/2014/9, as amended by Annex VII to the report of the 55th GRSP session). This proposal is submitted with a request for guidance on the use of references to an ISO Standard (ISO 15830:2013) instead of preparing an Addendum to the Mutual Resolution No. 1 (M.R.1.) for the WorldSID 50th male specifications.

Progress report on the efforts to achieve convergence in worldwide regulations governing the in-use and post-crash safety of equipment and subsystems specific to electrified vehicles via the development of UN Global Technical Regulations.

Working draft second edition to introduce envelope ISO/R2X, a version of the R2 envelope modified for improved compatibility with the vehicle interior, and a booster seat envelope ISO/F4.