This document provides a consolidated list of contributions from the IWG on AI experts to a literature review activity on Artificial Intelligence. References are organized by type and listed alphabetically, including standards such as ISO 21448:2022, ISO 23894, ISO 26262, ISO 22989, ISO 39003:2023, ISO/IEC 42001:2023, ISO/IEC TR 5469, ISO/PAS 8800:2024, ISO/SAE 21434:2021, ISO/TS 5083:2025, SAE J3016, SAE J3298, SAE J3312, and UL4600. Policy papers and research articles address trustworthy AI, autonomous vehicles, and safety.
Proposal to clarify that the Regulation does not apply to vehicles of categories X and Y, add an alternative approval pathway for certain vehicles using UN R152 requirements, allow continued extension of approvals for 12 months, amend paragraph 10 of Annex 1, and revise Annex 2 (approval mark arrangements).
The UN IWG on Cyber Security and OTA will meet April 21-22, 2026 via video conference. The agenda includes adoption of the provisional agenda and minutes from the previous session, proposals for amendments to UN R155 and its interpretation document regarding multistage vehicles and type approval authorities, review of cyber and software requirements in the ADS Regulation, discussion of RXSWIN application, renewal of the IWG mandate expiring November 2026, and confirmation of next steps.
Proposal to insert a new paragraph at the end of the introduction, amend paragraph 1 to clarify that the Regulation does not apply to vehicles of Categories X and Y, amend footnotes 1, 2, and 3 to reference document ECE/TRANS/WP.29/78/Rev.8, and insert new paragraph 5.6. with provisions that the LDWS function shall be deactivated upon activation of an ADS feature and automatically reinstated upon deactivation of an ADS feature.
Proposal to amend paragraph 1.1.1. to insert a new footnote 7 defining replacement brake lining assemblies; amend footnote 4 referencing the Consolidated Resolution on the Construction of Vehicles; and amend Annexes 3, 4, 7, 11, and 14 to establish special provisions for vehicles equipped with an Automated Driving System, including dedicated activation methods for braking tests, demonstration requirements for test activation method accuracy, recording of braking demand in test reports, and speed limitations at 90 per cent of vmax for vehicles of categories X and Y.
Proposal to amend paragraph 4.4.3. to add a letter “X” preceding the approval number when ACSF of Category A, B1 or C are exempted from technical requirements or when the steering system exhibits ACSF of Category B2, D or E functionality, to require vehicles equipped with ACSF of Category A to fulfil requirements unless equipped with a DCAS complying with UN Regulation No. 171, and to require deactivation of RCP systems based on driver position detection through a simple and obvious action.
Revised table for B.5.10. Annex: information document containing the essential characteristics of the propulsion units and the pollutant control systems.
Proposal concerning Type II test warming conditions.
Proposals concerning HC and CO limits for Type Ⅱ test.
ETRTO proposal about the tyre width selection for the method of measuring carbon dioxide emissions and fuel consumption.
IMMA comments on document EPPR-24-18, following discussion of the initial version within the EPPR informal group.
Proposal to replace “criteria pollutants” with “different tailpipe emissions” in paragraph 4.2.6.1.
Comments on the draft GTR amendments based on document EPPR-11-15.
Progress report on Korea research into the measurement of maximum engine power for motorcycles.
No matching documents.