|
Document title
|
UN R46: Proposal for Supplement 1 to the 06 series of amendments
|
|
Date
|
30 Jan 2024
|
Proposal to update the references to the three-dimensional H-point (3-D "H"-point) measurement and calibration procedure (per the update and transfer of specifications from the Consolidated Resolution on the Construction of Vehicles (R.E.3) to Mutual Resolution No. 1 (M.R.1)).
|
|
Source(s)
|
Netherlands
|
|
Status
|
Superseded
|
|
Rulemaking area(s)
|
|
|
Meeting(s)
|
|
|
Related documents
|
|
GRSG-126-20
|
MR1: Proposal for Amendment 5
|
|
GRSG-127-17
|
UN R46: Proposal for Supplement 1 to the 06 series of amendments (Superseded)
|
|
WP.29-194-12/Rev.1
|
UN R46: Proposal to amend document WP.29/2024/101 (Adopted by WP.29)
|
|
WP.29/2024/101
|
UN R46: Proposal for Supplement 1 to the 06 series of amendments (Adopted)
|
|
Downloads:
|
UNECE server
|
.pdf format
|
.docx format
|
GAR server
|
|
Excerpts from session reports related to this document
|
|
GRSG | Session 127 | 15-19
Apr 2024
|
12. As per paragraph 10, the expert from the Netherlands introduced ECE/TRANS/WP.29/GRSG/2024/21 (as amended by GRSG-127-24-17). GRSG adopted the proposal as amended below and requested the secretariat to submit them as part (see paragraph 11 above) of draft Supplement 1 to the 06 series of amendments to UN Regulation No. 46 for consideration and vote to the November 2024 sessions of WP.29 and AC.1.
Paragraph 8.1., amend to read:
| “8.1. | The procedures for conformity of production shall conform to the general provisions defined in Article 2 and Schedule 1 of the 1958 Agreement (E/ECE/TRANS/505/Rev.3) and meet the following requirements:” |
|