Proposal to correct values presented in document WP.29/2020/18 and clarification of “first point of information” application in assessment of BSIS.

Proposal to allow an alternative positioning and spacing of escape hatches on buses of Classes A and B to address limitations for shorter vehicles.

Proposal to introduce provisions for activation of a “temporary modified view” (such as change in image magnification or resolution) per ISO 16505:2015 to complement the static Class II field of vision using a Camera Monitoring System (CMS).

Proposal to clarify provisions for periodic testing and periodic requalification of Compressed Natural Gas (CNG) cylinders and Liquefied Natural Gas (LNG) tanks.

Proposal in line with ISO 2575 to allow for the use of different colors (e.g., red, yellow, green) to convey the status modes (e.g., failure, active) of seven functions via modification of footnote 18 under Table 1.

Proposal to add a missing footnote concerning the exemptions for heaters located outside the passenger compartment using water as a transfer medium and to clarify that it is not necessary to apply Annex 4 for the heat pump because the heat transfer fluid does not contain polluting air.

Proposal to correct erroneous references (to annexes in the regulation as well as to UN R94 and R95) in the text and to correct an inconsistency in the text (paragraph 26.7.2. refers to situations where the AECS is not equipped with a back-up power supply; however, the subparagraph 26.7.2.3. refers to an AECS with a back-up power supply).

Proposal to introduce a generic drawing to improve interpretation of the regulation, especially with regard to contactable parts (sphere protocol). The proposal clarifies which requirements apply to which part of the windscreen wiper and thus clarifies whether parts may be “exempted”. Given the implications for approvals, the proposal is presented as a new series of amendments with transitional provisions starting from September 2022.

Proposal to introduce electromagnetic specifications for the approval of an electronic device, such as a transponder — even without the traditional functionality of a mechanical key — under UN R62 via reference to UN R10 on electromagnetic compatibility (as is the case under UN R116).

Proposal to:

1. clarify that the application of an AECD approval to other vehicle categories than M₁ and N₁ is not mandatory,
2. align the power supply requirement of Part III, para. 34.1 with the corresponding requirement in Part II, para. 25.1.
3. clarify with regard to para. 34.1 that if the vehicle is equipped with both
   • -a “back-power supply” as listed in para. 35.10.1 and
   • -a “Power supply other than back-up power supply mentioned in paragraph 35.10.1” as listed in para. 35.10.2
   both should be tested according to Annex 9. The “Power supply other than back-up power supply mentioned in paragraph 35.10.1” should indeed only be tested if it is the only power supply for the AECS.
4. include two-year transitional provisions
5. remove the exclusion of M₁ and N₁ not equipped with a side airbag and to specify that the AECS shall be able to output the navigation solution in an NMEA-0183 protocol format (RMC, GGA, VTG, GSA and GSV message), among other clarifications.