International reference standards for harmonics and flicker testing define differing applicable supply voltage levels and operating frequencies. CLEPA proposes maintaining baseline requirements for UN R10.08 unchanged, testing according to standardized parameters of reference IEC standards. Contracting Parties with diverging local grid configurations should define tailored national requirements or propose harmonized evaluation methods directly within relevant IEC standard committees, as direct application or mathematical conversion of limits for diverging grids lacks standardized metrological foundation in IEC publications.

Proposal to amend Annexes 11 and 17 to specify an observation time of 2.5 min for quasi-stationary equipment as defined in Table 4 of IEC 61000-3-2, with the equipment operating in the mode expected to produce the maximum total harmonic current under normal operating conditions. Currently, UN R10.07 does not specify an observation time, which may lead to different interpretations of the test method and case-by-case agreement during type approval. Specifying 2.5 min would provide a consistent observation and averaging period for vehicle and ESA type-approval tests without changing existing test conditions, limits, or evaluation method.

Document raises question on the use of a combination of Level I/II immunity tests based on ISO 7637-2:2011 in the 07 series given that the 06 series prescribed Level III.

The session reviewed and adopted the draft agenda and prior meeting minutes. Substantive discussions addressed proposals including harmonics observation time for vehicles and energy storage assemblies (EMC-54-02), conducting automated driving system active tests (EMC-54-03), quality guidance for technical service test reports (EMC-54-04), amending UN R10 based on related regulations (EMC-54-05-Rev.1), minimum dwell time guidance (EMC-54-06), non-durable protection shields clarification (EMC-54-07), and transient immunity (EMC-54-10-Rev.1). The group concluded that further investigation and revised proposals are needed for several items by the December 2026 session. Next meeting: 2–3 December 2026 online.