Proposal to update UN R0 in line with the restructuring of the UN lighting regulations and to introduce use of the UN on-line system for sharing information on acceptance of type approvals.

Proposal to clarify the text to affirm that responsibility for implementing the provisions of the 1958 Agreement remains with the approval authority no matter which organization may be assigned to carry out specific duties.

Proposal to exempt Zone I from opaque obscuration requirements of GTR 6 under certain conditions to facilitate the installation of devices such as rain-drop sensors, inside mirrors or automated vehicle sensors, etc..

Information on several national projects to develop driving scenario databases to define conditions that automated vehicles need to navigate in real-world operation.

Proposal from the IWVTA informal group for amendments, including replacing a reference to the type approval number with the VIN, to the annex concerning “Specifications of the IWVTA DoC”.

Proposal to clarify the possibility to install side-facing seats in buses of category M2 and M3 of classes A and I.

Proposal to cease new CRS approvals under UN Regulation No. 44 as of 1 September 2020, including amended transitional provisions.

Proposal to

1. introduce new and modified labeling and to clarify packaging information to distinguish between forward-facing-only, rear-facing-only, and convertible CRS in order to reduce the risk of users misusing these enhanced CRS, and
2. clarify that assessment of the DE plane only applies to rearward-facing Child Restraint Systems (CRS) in UN Regulation No. 44 and therefore does not apply to forward-facing child restraints that maintain structure of the child restraint behind the head of the dummy.

Proposal to

1. introduce new and modified labeling and to clarify packaging information to distinguish between forward-facing-only, rear-facing-only, and convertible CRS in order to reduce the risk of users misusing these enhanced CRS, and
2. clarify that assessment of the DE plane only applies to rearward-facing Child Restraint Systems (CRS) in UN Regulation No. 44 and therefore does not apply to forward-facing child restraints that maintain structure of the child restraint behind the head of the dummy.

Proposal to

1. introduce new and modified labeling and to clarify packaging information to distinguish between forward-facing-only, rear-facing-only, and convertible CRS in order to reduce the risk of users misusing these enhanced CRS
2. clarify that assessment of the DE plane only applies to rearward-facing Child Restraint Systems (CRS) in UN Regulation No. 44 and therefore does not apply to forward-facing child restraints that maintain structure of the child restraint behind the head of the dummy
3. specify the dimensions of the approval number
4. correct the term “Regulation No. 129-02” to “UN Regulation No. 129/02”
5. change the 145 cm stature of the Specific Vehicle Booster seat to the 150 cm stature as this is the upper limit, and
6. modify the approval markings for consistency between technical services and approval authorities and between the labels of products approved under the 02 and 03 series.

Proposal to

1. introduce new and modified labeling and to clarify packaging information to distinguish between forward-facing-only, rear-facing-only, and convertible CRS in order to reduce the risk of users misusing these enhanced CRS
2. clarify that assessment of the DE plane only applies to rearward-facing Child Restraint Systems (CRS) in UN Regulation No. 44 and therefore does not apply to forward-facing child restraints that maintain structure of the child restraint behind the head of the dummy
3. specify the dimensions of the approval number
4. update i-Size universal ISOFIX, Specific Vehicle ISOFIX, i-Size Booster seat and Specific Vehicle Booster seat numbering (omitted in WP29-2018-045)
5. rearrange the dimensions mark for arrangements of the approval mark where used in combination with the module mark
6. change the 145 cm stature of the Specific Vehicle Booster seat to 150 cm stature as this is the correct upper limit, and
7. clarify that Conformity of Production assessments shall be conducted under the same requirements as those of the original approval or, if applicable, the extension of the approval.

Proposal to align the provisions of the 03 series of amendments to UN R24 with UN R85. Other amendments are proposed in order to bring the format of UN R24 up to date.

Proposal to

1. clarify the relationship between approval levels, reference fuels and PN limits for PI vehicles and to modify the calculation formulae for determination of evaporative emissions in accordance with changes already agreed in UN GTR No. 19
2. correct errors in Working Paper 2019.08
3. expand 2019.08 to clarify the special provisions, and
4. resolve a contradiction in requirements concerning the provision of SCR reagent consumption data via the serial port of the standard diagnostic connector.

Proposal to

1. clarify the relationship between approval levels, reference fuels and PN limits for PI vehicles and to modify the calculation formulae for determination of evaporative emissions in accordance with changes already agreed in UN GTR No. 19
2. correct errors in Working Paper 2019.08
3. expand 2019.08 to clarify the special provisions, and
4. resolve a contradiction in requirements concerning the provision of SCR reagent consumption data via the serial port of the standard diagnostic connector.

Proposal to reduce testing burdens by introducing an alternative test method to “decrease the charge air cooler outlet temperature by the same amount that the ambient conditions for the vehicle test varied from the standard temperature.” This aligns with SAE J1349, “9.3 Application of Vehicle Transient Data to Net Power Test.”

Proposal to align UN R115 with the GTR No. 15 WLTC test cycle.

Proposal to introduce provisions relevant to the activation of stop lamps under more conditions than application of the service brake only, e.g. also by regenerative braking.

Proposal to align the text in Annex 7 with UN R78 and to insert the reference to the L₆ and L₇ vehicle categories to respond to requests from the industry for type approval for the replacement brake lining assembly for these vehicles.

Proposal to clarify that UN R139 does not mandate the installation of brake assist systems (BAS) on vehicles but rather specifies requirements for the approval of vehicles should they be equipped with a BAS system.

Proposal to clarify that UN R140 does not mandate the installation of electronic stability control systems (ESC) on vehicles but rather specifies requirements for the approval of vehicles should they be equipped with an ESC system.

Proposal to introduce a definition for “Extended Mobility Tyre” based on a new “minimum requirement” performance test procedure with the relevant pictogram to be used to properly distinguish such tyres and to ensure that that P-type tyres can be distinguished from non-P-type tyres.

Proposal to correct a reference in Supplement 3 to the 03 series of amendments, to introduce transitional provisions in line with the transitional provisions in Supplement 3, and to reintroduce a sentence deleted by mistake in Supplement 4 to the 03 series of amendments to UN Regulation No. 51.

Proposal to amend UN R64 in line with the introduction of the “extended mobility tyre” into UN R30 (see document WP.29/2019/50).

Proposal to clarify the identification, marking and test provisions applicable to tyres designed for speeds above 240 km/h.

Proposal to

1. correct a type in Annex 7- Appendix 2, Part 2, Paragraph 5 where the snow group index should read “1.00”, not “100” as appeared erroneously in the adopted text
2. correct the text where the word “tyres” was inadvertently omitted from Paragraph 2.1.
3. align the provisions of UN R117 regarding approval numbers and markings with the provisions of Schedule 4 to the revised 1958 Agreement.

Proposal to

1. exempt hybrid vehicles that do not provide valid test results (e.g., internal combustion engine active under test conditions)
2. clarify the text concerning permissible AVAS operating conditions
to differentiate indoor and outdoor facility requirements (e.g., weather station requirement) and
3. update flowcharts in Annex 3 in line with text.
4. add a footnote to the scope to exempt electrified vehicles where the internal combustion engine (ICE) operates under the test conditions
5. clarify the intention of paragraph 6.2.:
   • that AVAS may be operational outside the specified speed ranges (e.g., in the USA where the speed range extends to 30 km/h),
   • align maximum sound with UN R51.03 ASEP, and
   • explicitly specify that the AVAS may function even when the ICE is running
6. clarify under paragraph 6.2.6. that a manufacturer may install an attenuation to enable the system to operate at different sound levels
7. split and clarify indoor and outdoor testing specifications under Annex 3 paragraph 2.2. to account for different needs such as a weather station
8. amend the flowcharts in the Annex 3 Appendix to better reflect the regulation text
9. align the transitional provisions in the 01 series of amendments with the format introduced following Revision 3 of the 1958 Agreement.

Proposal to update a reference regarding ISOFIX exemptions permitted under paragraph 5.3.8.8. (related to vehicles with one seat position per row). The reference should read 5.3.8.8. and 5.3.8.9.

Proposal to update a reference regarding ISOFIX exemptions permitted under paragraph 5.3.8.8. (related to vehicles with one seat position per row). The reference should read 5.3.8.8. and 5.3.8.9.

Предложение по исправлению 3 к первоначальному варианту Правил ООН № 129 (усовершенствованные детские удерживающие системы): English wording “Upper neck tension force” corresponds to the following Russian wording “Сжимающая сила верхней части шеи”. English wording “Upper neck flexion moment” corresponds to the following Russian wording “Изгибающий момент верхней части шеи”.

Proposition de rectificatif 1 à la série 03 d’amendements au Règlement ONU no 129 (Dispositifs améliorés de retenue pour enfants): Proposal to align the French version with the adopted English version of the text (reference document WP.29/2018/45).

Proposal from the GRPE secretariat to correct omissions found in document WP.29/2018/148 (proposal for Supplement 8 to the 07 series of amendments) as adopted by WP.29.

Proposal for uniform provisions concerning the approval of motor vehicles with regard to the Advanced Emergency Braking System (AEBS) for M₁ and N₁ vehicles.

Series of proposals from the WLTP informal group to improve and clarify the text of GTR 15 on light vehicle emissions.

Proposal to introduce improvements and amendments concerning the evaporative emission family definitions and the Type 4 test procedures with regard to test equipment requirements and calibrations, evaporative emission measurement enclosures, and use of variable volume SHED facilities

Amendments to the global technical regulation on evaporative emissions to address:

1. Calibration requirements and intervals for test equipment;
2. Equation for the variable-volume enclosures;
3. Improvements to the text:
   1. Clarification of aged carbon canister and when to install;
   2. Clarification and review of test equipment;
   3. Clarification and review of requirements of an evaporative emission family;
   4. Clarification of “carbon canister”;
   5. Change to the term “carbon canister” used to catch depressurisation puff loss overflow.

Règlement technique mondial sur la procédure d’essai mondiale harmonisée pour les voitures particulières et véhicules utilitaires légers (WLTP); Note du secrétariat; Rectificatif

Règlement technique mondial sur la procédure d’essai mondiale harmonisée pour les voitures particulières et véhicules utilitaires légers(WLTP); Amendement 1; Note du secrétariat; Rectificatif

Règlement technique mondial sur la procédure d’essai mondiale harmonisée pour les voitures particulières et véhicules utilitaires légers (WLTP); Amendment 2; Note du secrétariat; Rectificatif

Règlement technique mondial sur la procédure d’essai mondiale harmonisée pour les voitures particulières et véhicules utilitaires légers(WLTP); Amendement 3; Note du secrétariat; Rectificatif

Règlement technique mondial sur la procédure d’essai mondiale harmonisée pour les voitures particulières et véhicules utilitaires légers (WLTP); Amendement 4; Note du secrétariat; Rectificatif

Submission by the secretariat revising the timeline of ECE/TRANS/WP.29/AC.3/51 to reflect the updated timeline, as agreed during the seventy eighth session of GRPE in January 2019.

Proposal to clarify requirements of the optical signal for a CSF intervention to ensure sufficient flashing tell-tale visibility for the driver, to specify the duration of such ACSF signals, to ensure a safe hierarchy of signals (e.g., ESF over CSF) by priority, to clarify that deactivation when departing an ODD means the “off mode”, and to add a cross-reference pointing to paragraphs that define cases of manual and automatic deactivation.