Proposal to update references to the three-dimensional “H” point measurement and calibration procedure pursuant to the transposition of these provisions into Mutual Resolution No. 1.
4. GRSP noted that the Executive Committee of the 1998 Agreement (AC.3) at its March 2024 session had adopted the authorization (ECE/TRANS/WP.29/2024/32) to develop amendments to UN GTRs Nos. 6 (Safety Glazing), 7 (Head Restraints) and 14 (Pole side impact) which would allow the transfer of the reference, drawings and specification on the three-dimensional H- (3-D H-) point machine and calibration procedure from the UN GTRs to Mutual Resolution No. 1 (M.R.1). The expert from the Kingdom of the Netherlands, which sponsors the amendment, introduced ECE/TRANS/WP.29/GRSP/2024/8 amending the UN GTR and the final report of the amendment work (GRSP-75-20-Rev.1). Finally, GRSP recommended ECE/TRANS/WP.29/GRSP/2024/8, not amended, as Amendment 2 to UN GTR No. 7 and its final report GRSP-75-20-Rev.1 (as reproduced in annex II to this report) to the November 2024 session of AC.3.
6. As per paragraph 4, the expert from the Kingdom of the Netherlands, which sponsors the amendment, introduced ECE/TRANS/WP.29/GRSP/2024/9 amending the UN GTR and the final report of the amendment work (GRSP-75-20-Rev.1). GRSP recommended ECE/TRANS/WP.29/GRSP/2024/9, not amended, as Amendment 1 to UN GTR No. 14 and its final report GRSP-75-20-Rev.1 to the November 2024 session of AC.3.
| GRSP-75-20/Rev.1 | |
| WP.29/2024/163 |