Revision 1 has been prepared purely as documentation tool. The authentic and legally binding texts are WP.29/2010/102 and WP.29/2011/32. This document incorporates the following changes:

Revision 1 | Amendment 1 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2012/18. This document incorporates the following change:

Revision 1 | Amendment 2 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2012/84. This document incorporates the following change:

Proposal as adopted by GRE at its 67th session to introduce provisions for the use of light-emitting diode (LED) light sources per the draft LED Regulation (Regulation No. 127: documents WP.29/2010/44 and Corr.1) and to improve the definition of the zones in the photometric requirements.

Revision 1 | Amendment 3 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2013/24. This document incorporates the following change:

Text as adopted by the Working Party on Lighting and Light Signalling (GRE) at its 68th session to delete the 1cd requirement for geometrical visibility.

Revision 1 | Amendment 4 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2015/31. This document incorporates the following change:

According to Regulation No. 119, cornering lamps that are equipped with light sources other than filament lamps, are required to meet the relevant photometric requirements after one minute and after 30 minutes of operation. However, under normal traffic conditions, these lamps are operated for no more than 6 minutes. This proposal as approved by the GRE would would require the second test after 10 minutes instead of the current 30 minutes, in accordance with standard SAE J1889.

Revision 1 | Amendment 5 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2017/40. This document incorporates the following change:

Proposal to:

1. insert provisions for the use of incandescent light sources in the case of light source modules and lamps with non-replaceable light sources,
2. update the Conformity of Production (CoP) requirements,
3. reference the compliance requirements for installation contained in Regulations Nos. 48, 53, 72 and 86,
4. clarify the definition of “type”, with regard to manufacturer, trade names and marks,
5. introduce editorial improvements to the requirements for markings,
6. remove content in paragraph 7.5 that should have been deleted when the text was moved to Annex 3, paragraph 3.3. (via Supplement 4 to the 01 series),
7. remove the requirement to indicate the rated wattage in the marking of lamps equipped with electronic light source control gear and/or non-replaceable light sources and/or light source module(s), and
8. refine the requirements for lamps equipped with several light sources, including in systems fitted with an operating tell-tale that indicates the failure of any one of these light sources.

Revision 1 | Amendment 6 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2017/88. This document incorporates the following change:

Proposal to clarify the requirements for light sources in the lighting and light-signalling Regulations listed in Annex 4 to Regulation No. 0 on the International Whole Vehicle Type Approval (IWVTA).

Revision 1 | Amendment 7 has been prepared purely as documentation tool. The authentic and legally binding text is WP.29/2018/118/Rev.1. This document incorporates the following change:

Proposal from GRE to introduce transitional provisions for the phasing out of UN R119 in conjunction with the introduction of the new UN Regulation on Road Illumination Devices (RID).