Review on the possible direction
(1) new series of amendment
(2)single series structure

Calibration of measurement equipment to PN10 measures more particles than calibration to PN23. It is therefore logical that compliance with a limit when measured according to PN10 demonstrates compliance with the same limit according to PN23 but this text should be added for legal certainty.

Proposal to introduce optional calculation method for determining f₀ and f₂ road load coefficients, allow measurement of drivetrain delta on component dynamometer, permit evaluation of split runs to increase data base, and enable test vehicle configuration using interpolation method. The calculation method determines final f₀ and f₂ values considering theoretical delta between coast down vehicle and final vehicle. Component dynamometer measurement increases accuracy because not all combinations of road load relevant components can be assembled, allowing all component combinations to be evaluated independently.

Annex to GRPE 92-08

Proposal concerning the approval of the wind tunnel facilities.

Proposal to bring clarity in the text relating to On-Board Diagnostics (OBD).

Consolidated revision to make corrections, clarifications and improvements that have already been introduced into the 02 and 03 series of amendments of UN R154. The proposal is based on document GRPE/2024/2, GRPE-90-11-Rev.1, and GRPE-91-11 PEV run-in provisions only).

Consolidated revision to make corrections, clarifications and improvements that have already been introduced into the 02 and 03 series of amendments of UN R154. The proposal is based on document GRPE/2024/3, GRPE-90-11-Rev.1, and GRPE-91-11 PEV run-in provisions only).

Proposal to amend additive deterioration factors and the PEV run-in requirement and to effect corrections and editorial improvements.

Proposal to align the manufacturer information document with the type-approval
certificate.