Document Number GRSP/2024/9
1 2 3 4 5 6 7 8 9 10
Document title GTR 14: Proposal for Amendment 1
Date 18 Mar 2024

Proposal to update references to the three-dimensional “H” point measurement and calibration procedure pursuant to the transposition of these provisions into Mutual Resolution No. 1.

Source(s) Netherlands
Status Superseded
Rulemaking area(s)
Meeting(s)
Related documents
GRSP-75-20/Rev.1 Report on development of Amendment 4 to GTR 6, Amendment 2 to GTR 7, and Amendment 1 to GTR 14 (Superseded)
WP.29/2024/164 GTR 14: Proposal for Amendment 1 (Adopted by WP.29)
Downloads: UNECE server .pdf format .docx format GAR server
Excerpts from session reports related to this document
GRSP | Session 75 | 27-31 May 2024

6. As per paragraph 4, the expert from the Kingdom of the Netherlands, which sponsors the amendment, introduced ECE/TRANS/WP.29/GRSP/2024/9 amending the UN GTR and the final report of the amendment work (GRSP-75-20-Rev.1). GRSP recommended ECE/TRANS/WP.29/GRSP/2024/9, not amended, as Amendment 1 to UN GTR No. 14 and its final report GRSP-75-20-Rev.1 to the November 2024 session of AC.3.

4. GRSP noted that the Executive Committee of the 1998 Agreement (AC.3) at its March 2024 session had adopted the authorization (ECE/TRANS/WP.29/2024/32) to develop amendments to UN GTRs Nos. 6 (Safety Glazing), 7 (Head Restraints) and 14 (Pole side impact) which would allow the transfer of the reference, drawings and specification on the three-dimensional H- (3-D H-) point machine and calibration procedure from the UN GTRs to Mutual Resolution No. 1 (M.R.1). The expert from the Kingdom of the Netherlands, which sponsors the amendment, introduced ECE/TRANS/WP.29/GRSP/2024/8 amending the UN GTR and the final report of the amendment work (GRSP-75-20-Rev.1). Finally, GRSP recommended ECE/TRANS/WP.29/GRSP/2024/8, not amended, as Amendment 2 to UN GTR No. 7 and its final report GRSP-75-20-Rev.1 (as reproduced in annex II to this report) to the November 2024 session of AC.3.