17. The expert from CLEPA also presented GRRF-81-06, proposing amendments to Regulation No. 55 in the case of Multiple Vehicle Combinations. GRRF as well as the IWG on MVC supported in principle the proposal and requested that the IWG on Regulation No. 55 prepares an official document for consideration at the next GRRF session.

18. The expert from CLEPA introduced GRRF-81-07, proposing the procedure to identify allowable combinations of performance values Dc and V for drawbar coupling equipment. The expert from the UK noted that an editorial correction would be needed in paragraph 4.1.1. and proposed to assist the Secretary of the IWG to prepare an official document for consideration at the next GRRF session.

17. The Secretary of the IWG introduced ECE/TRANS/WP.29/GRRF/2016/29 (amended by GRRF-82-27) with technical requirements for coupling devices for the purpose of modular vehicle combinations as well as “in-use” requirements for the combination of vehicles. The proposal, supported by GRRF, received some comments about the possibility to verify, at the time of type approval, the compliance with these “in use” requirements. GRRF questioned whether a driver could be requested to verify during a coupling phase the compatibility requirements defined in the proposal. The expert from CLEPA showed that calculation tools were available on the website of his company (www.vbg.se) and argued that it would be possible. GRRF agreed that this aspect of the proposal would need further consideration by the IWG who should recognise that new measures must be enforceable via type approval.

17. The Secretary of the IWG introduced ECE/TRANS/WP.29/GRRF/2016/29 (amended by GRRF-82-27) with technical requirements for coupling devices for the purpose of modular vehicle combinations as well as “in-use” requirements for the combination of vehicles. The proposal, supported by GRRF, received some comments about the possibility to verify, at the time of type approval, the compliance with these “in use” requirements. GRRF questioned whether a driver could be requested to verify during a coupling phase the compatibility requirements defined in the proposal. The expert from CLEPA showed that calculation tools were available on the website of his company (www.vbg.se) and argued that it would be possible. GRRF agreed that this aspect of the proposal would need further consideration by the IWG who should recognise that new measures must be enforceable via type approval.

20. The expert from Germany volunteered to prepare a consolidated document encompassing all documents above (see paras. 16-19) while addressing the comments received. GRRF requested for this new document to be brought to the next session.