Proposal to:

• Amend para. 6.1.1.2. to differentiate rearview mirror edge requirements between Classes II to VII and Class I,
• amend para. 6.1.1.3. to specify radius of curvature requirements for mirror parts in static contact with spheres,
• amend para. 6.1.1.4. to clarify requirements for protruding parts and introduce a method for determining projection dimensions,
• insert new para. 6.1.1.4.1. to permit determination of component projection either directly or by drawing reference,
• insert new para. 6.1.1.4.2. to specify measurement by maximum sphere distance variation for non-convex surfaces with Figure 1 example,
• amend para. 6.1.1.5. to exempt edges of fixing holes or recesses with diameter or longest diagonal less than 12 mm,
• amend para. 6.1.1.6. to require attachment device design accommodating a cylinder with 70 mm radius (50 mm for L-category vehicles),
• amend para. 6.1.1.7. to exempt exterior mirror parts with Shore A hardness not exceeding 60,
• insert new para. 6.1.1.8. to apply requirements only to rigid supports for interior mirror parts with Shore A hardness less than 50,
• insert new para. 6.1.1.9. to exempt mirrors mounted not less than 2 m above ground at maximum technical permissible mass from para. 6.1.1.3. requirements.