Discussion paper concerning the approval markings that might be used under the international whole vehicle type approval system in association with approval codes, numbers, or markings required by individual UN Regulations.

Proposed changes to the article concerning the procedure for amendments to UN Regulations.

Proposal to amend the draft agreement to address situations where a Contracting Party disagrees with an adopted amendment and ceases to apply a given UN Regulation. The proposal seeks to clarify that the Contracting Party would still be obligated to accept type approvals based on the previous versions of the regulation (i.e., approvals based on versions of the regulation that the CP had been accepting before the amendment) for one year following its notification to cease application of the regulation.

Schedule 4 of the draft revision 3 of the 1958 Agreement concerns the type approval numbering system for UN approvals. The numbering example reads: E11*83R03/00J*2439*01. In its second section it contains the letter J for indicating implementing stage J of UN Regulation 83. According to Schedule 4, point 2, under ©, that letter J should be preceded by a slash; however that slash is missing in the given example. It is suggested to correct this typing error by replacing the relevant example by the following example: E11*83R03/00/J*2439*01.

Q&A on Revision 3 of the 1958 Agreement.

Revision 3 of the 1958 Agreement allows for a Unique Identifier (UI) under the DETA system as an alternative to the current approval mark. In the case of child restraint systems, the approval mark contains important information for users. Therefore, this proposal would prohibit replacement of the approval mark by the UI.