Proposal to require marking of extension numbers on accessories relevant to the UN R67 bonfire test (e.g., multivalve, pressure relief valve, pressure relief device) in order to prevent/prohibit the misuse (in container configurations) of these accessories. The proposal includes provisions for components where such marking is impractical based upon text drawn from UN R46.

34. Finally, GRSG considered a revised proposal (GRSG-113-36) and adopted ECE/TRANS/WP.29/GRSG/2017/30 as amended below.

Part I, paragraph 4.2., amend to read:

35. The secretariat was requested to submit the proposal to WP.29 and AC.1 as part (see paras. 31 and 32 above) of draft Supplement 15 to the 01 series of amendments to UN Regulation No. 67 for consideration at their March 2018 sessions.

Proposal for new safety provisions with regard to LPG systems having hydraulic interconnections with the petrol or diesel fueling system through which inter-flows of fuels may occur.

31. The expert from AEGPL presented ECE/TRANS/WP.29/GRSG/2017/26 proposing to insert new safety provisions into UN Regulation No. 67 on LPG systems that have hydraulic interconnections with the petrol or diesel fuelling system through which inter-flows of fuels may occur. GRSG adopted the proposal, as amended below, and requested the secretariat to submit it to WP.29 and AC.1 as draft Supplement 15 to the 01 series of amendments to UN Regulation No. 67 for consideration at their March 2018 sessions.

New paragraph 2.22., replace “Interconnected LPG-system” by “Interconnected LPG-system (ICS)”.

Proposal to establish procedures for the approval of non-seamless gas tube(s), gas tube(s) made of materials other than copper, stainless steel, and steel with corrosion-resistant coating, and their couplings in Liquefied Petroleum Gas (LPG) vehicles provided they can withstand the applicable tests according to Annex 15.

32. Referring to ECE/TRANS/WP.29/GRSG/2017/27, the expert from AEGPL recalled the purpose of his proposal to clarify the provisions in UN Regulation No. 67 on the use of non-seamless gas tubes in LPG vehicles. GRSG adopted the document, as amended below, and requested the secretariat to submit it to WP.29 and AC.1 as part (see para. 31 above) of draft Supplement 15 to the 01 series of amendments to UN Regulation No. 67 for consideration at their March 2018 sessions.

Paragraph 2.2., subparagraph (s), amend to read:

“(s) Non-seamless and seamless gas tubes and their couplings;”

New paragraph 17.7.1.2., amend to read:

Annex 15, paragraph 5., replace “Only longitudinal welding” by “Only straight longitudinal welding”.

Proposal presented as an alternative to the previous proposal from Poland (GRSG/2017/10) to require manufacturers to mark the approval extension number on any accessories relevant to the bonfire test (multivalve or, when approved separately, pressure relief valve (discharge valve) and pressure relief device) so that the fitting of any accessory not on the list of approved configurations (Table 3 in the appendix of Annex 2B) will be prevented/forbidden. This solution would imply a new requirement in Annex 2A for the marking of the accessories fitted to the containers.

33. Recalling the discussion on ECE/TRANS/WP.29/GRSG/2017/10 at the previous GRSG session, the expert from AEGPL presented ECE/TRANS/WP.29/GRSG/2017/30 to further clarify the provisions for type approved accessories fitted to LPG containers and to insert an additional indication mark. The expert from Poland raised a study reservation and introduced the obligation to mark the products with the designation of the version, variant and the extension number of the type-approval certificate (GRSG-113-09). Both proposals received a number of comments.

34. Finally, GRSG considered a revised proposal (GRSG-113-36) and adopted ECE/TRANS/WP.29/GRSG/2017/30 as amended below.

Part I, paragraph 4.2., amend to read:

35. The secretariat was requested to submit the proposal to WP.29 and AC.1 as part (see paras. 31 and 32 above) of draft Supplement 15 to the 01 series of amendments to UN Regulation No. 67 for consideration at their March 2018 sessions.