Proposal to amend and supersede document ECE/TRANS/GRSG/2026/16. Supplement 1 to the 01 series of amendments to UN R166 addresses vehicles of categories X and Y. Vehicles of category Y and category X without manual mode intended for on-board operation are exempted from the scope. Vehicles of category X equipped with manual mode seated in a driver’s seat must comply with general provisions. Manual operation other than seated in a driver’s seat may apply alternative provisions. The Regulation applies to vehicles of category M1 and N1. New definitions of “Safety Concept” are introduced. Requirements address close-proximity front and lateral field of vision from adjusted driver’s ocular points.
New paragraphs introduce provisions for vehicles of categories X and Y and vehicles with manual mode operating above 6 km/h equipped with an Automated Driving System. The regulation extends application to vehicles without driver and manual driving controls. Special provisions or exemptions do not apply to vehicles equipped with an ADS other than categories X and Y in manual or automated driving mode. Footnotes amended to reference ECE/TRANS/WP.29/78/Rev. 8.
Proposal to amend UN R167 to account for vehicles of categories X and Y. Vehicles of category Y and category X without manual mode intended for on-board operation are exempted from this Regulation. Vehicles equipped with an ADS must comply when operated manually by a driver on-board. Three manual modes are considered: remote-control operation near the vehicle (exempted), seated operation in driver’s seat (general provisions apply), and on-board operation other than seated (alternative provisions apply). Regulation applies to vehicles of categories M₂, M₃, N₂ and N₃. New definitions and approval mark arrangements are introduced. This document is intended to amend and supersede document ECE/TRANS/GRSG/2026/24.
Proposal for supplement 45 to UN R61 to amend the Regulation to account for vehicles of categories X and Y without driver, driver cab, and manual driving controls, as well as vehicles with manual mode operating at speeds above 6 km/h equipped with an Automated Driving System Feature of Type 2. The amendments modify definitions of external surface and cab rear panel, introduce definitions for ADSF-1 and ADSF-2, and specify that in modes where an ADS feature is active, basically the same requirements apply regarding external projections.
Proposal to amend UN R46 to introduce Supplement 1 to the 07 Series of Amendments addressing vehicles of categories X and Y, and vehicles with manual mode operating above 6 km/h equipped with an Automated Driving System. The Regulation does not apply to vehicles of category Y. For vehicles of category X with manual driving mode operated on-board not using a driver’s seat, alternative requirements demonstrating equivalent safety may apply in agreement with the Technical Service and Type Approval Authority.
Proposal to amend UN R43 (Safety Glazing) to take into account vehicles of category X and Y, as well as vehicles with manual mode operating at speeds above 6 km/h equipped with an Automated Driving System Feature of Type 2. The Regulation is extended to vehicles without driver and without manual driving controls. Different manual modes are considered: remote-control operation, seated in driver’s seat, and onboard operation other than seated in driver’s seat. No windscreen is required on such vehicles lacking manual mode operated on-board the vehicle driver’s seat. Requirements for light transmittance and safety glazing material are specified, with alternative provisions for vehicles without a driver’s seat.
No documents available.