Y-category vehicles are equipped with an Automated Driving System and not designed to carry occupants. They may develop aggressive front structures that could harm passenger cars in accidents. The proposal introduces the Occupant Load Criterium (OLC), derived from velocity-time graphs in crash tests, as a compatibility assessment criterion. OLC multiplied by vehicle mass indicates impact aggressivity. Data from ODB tests show OLC values range from approximately 22 to 35 g across various vehicles. The proposal suggests using a maximum OLC × mass value to prevent excessively aggressive vehicle front structures while keeping current passenger car designs unaffected.
A decision was taken in mid-2025 to start drafting a new regulation collecting relevant safety requirements for Category Y vehicles. UN R127 on pedestrian safety performance could be directly amended to include Y-category vehicles instead of including requirements in a new regulation. TF AVRS agreed to amend UN R127 to include Y-category vehicles. A draft regulation (v4) is available proposing supplement 5 to the 04 series of amendments, including amendment suggestions in scope to determine exemptions for Y-category vehicles based on front structural geometry dimensions rather than R-point criteria.
A new UN Regulation is being drafted for N1vehicles of category Y (vehicles equipped with an automated driving system, not capable of manual driving exceeding 6 km/h, and not designed to carry occupants). The draft incorporates crash safety requirements from UN R94, UN R95, UN R137, and UN R153. Draft version 5 adds provisions for simplified approval procedures for previously approved vehicles, references UN R137 for vehicles between 2,500 and 3,500 kg, and clarifies B pillar references. Open issues include confirming non-applicability of lateral collision partial tests and clarifying which simplified procedures are permitted.
The 42nd IWG on A-LCA session met to review the document package for GRPE submission. The group discussed three submission options: a working document with open issues; agreed provisions only with open issues in a separate informal document; or agreed provisions only with open issues remaining within the IWG. No final decision was taken. Further discussions are required on Pre-consumer Scrap, Chain of Custody, Electricity Modelling, OVC-HEV, FCV, Battery and Powertrain Replacement. A dedicated electricity modelling meeting will be held on 30 June 2026, and the 43rd session is confirmed for 6 July 2026.