1 2 3 4 5 6 7 8 9 10
Document Title Addendum to document GRRF/2017/18
Reference Number GRRF-84-34
Date
24 Sep 2017
Summary Proposal to correct the paragraph numbering of the original proposal for amendments to Regulation No. 54 contained in document GRRF/2017/18. The introduction of new paragraphs by Supplement 21 and the separation of paragraph 3.1. into subparagraphs 3.1.1. and 3.1.2. result in the proposed paragraph 3.1.12. being renumbered as 3.1.13.
Source(s) ETRTO
Rulemaking Area(s) UN R54 CV Tires
Proposal Status Superseded
Meeting(s)
Related Documents
GRRF/2017/18 Proposal for amendments to Regulation No. 54 (superseded)
Downloads
UNECE server .pdf format .docx format
Excerpts from session reports related to this document
GRRF | Session 84 | 19-22 Sep 2017

28. The expert from ETRTO introduced ECE/TRANS/WP.29/GRRF/2017/18 as amended by GRRF-84-16 with editorial correction and a number of imperial tyre sizes updated in Annex 5.

29. GRRF agreed to adopt the proposed amendment to paragraph 3.4. (based on GRRF‑84-34) as reproduced below:

Paragraph 3.4., amend to read:

"3.4.The markings referred to in paragraph 3.1. and the approval mark prescribed in paragraph 5.4. of this Regulation shall be moulded on to or into the tyres. They shall be clearly legible and shall, except for the marking referred to in paragraphs 3.1.1., 3.1.2. and 3.1.13. above, be located on at least one lower sidewall."
30. The expert from ETRTO volunteered to prepare a revised proposal for the February 2018 session of GRRF to address the comments received on some provisions proposed in ECE/TRANS/WP.29/GRRF/2017/18.

28. The expert from ETRTO introduced ECE/TRANS/WP.29/GRRF/2017/18 as amended by GRRF-84-16 with editorial correction and a number of imperial tyre sizes updated in Annex 5.

29. GRRF agreed to adopt the proposed amendment to paragraph 3.4. (based on GRRF‑84-34) as reproduced below:

Paragraph 3.4., amend to read:

"3.4.The markings referred to in paragraph 3.1. and the approval mark prescribed in paragraph 5.4. of this Regulation shall be moulded on to or into the tyres. They shall be clearly legible and shall, except for the marking referred to in paragraphs 3.1.1., 3.1.2. and 3.1.13. above, be located on at least one lower sidewall."
30. The expert from ETRTO volunteered to prepare a revised proposal for the February 2018 session of GRRF to address the comments received on some provisions proposed in ECE/TRANS/WP.29/GRRF/2017/18.
New and Upcoming
System Pages
Regulations
Working Groups
GlobalAutoRegs
© 2025 GlobalAutoRegs