Proposal to insert new para. 3.3. requiring that the use of non-durable protection shields (e.g., non-integral ferrite blocks, aluminium foil) shall be prevented, and if used, shall be duly described in the information document and test report.
Proposal to amend Table 2 in Annex 4, paragraph 4.3. to add “Scanning receiver parameters” as heading and add footnote b to minimum dwell time columns stating the selected dwell time shall, in addition, consider the cycle time of certain vehicle functions, e.g. the wiper system, amend Table 2 in Annex 5, paragraph 4.3. to add “Scanning receiver parameters” as heading and add footnote a with identical language, and amend Annex 6, paragraph 4.1. to add language that the selected dwell time shall, in addition, be sufficient for the observer(s) to assess all related vehicle functions, while also considering the cycle time of certain vehicle functions, e.g., the wiper system.
Proposal to insert a new definition of functional test configuration, amend para. 2.1.1.2. to clarify that test conditions are agreed between manufacturer and technical service and that tables provide guidance which may be extended or amended depending on vehicle characteristics, add tables specifying basic vehicle test conditions for “50 km/h mode,” “Brake mode,” and “Active ADS Mode,” add an alternative “Brake mode” with active ADS for vehicles where braking mode cannot be applied with ADS operational without ADS feature(s) activated, add AECS and AVAS test condition tables, and insert a new table cross-referencing UN Regulations with specific provisions and test configurations to demonstrate compliance with UN R10.
Proposal to require test reports provided by manufacturers to comply with paragraph 3.3. and to be attached to the test report of the technical service.
Proposal for conducting the ADS Active Test Specified in Annex 6 to clarify ADS Active Mode, clarify methods to activate ADS using test equipment or by modifying in-vehicle ADS-related ECU software, clarify test objects for ESA at component-level or system-level, and clarify test methods when ADS cannot be activated in an anechoic chamber, including testing in a non-active state using warning indicators and diagnostic functions, and testing when errors occur upon ADS activation. The proposal defines ADS Active Mode as representative ADS functions remaining operational using sensors whose inputs can be simulated within the anechoic chamber environment, with alternative test methods including application based on ESA or subsystem test results, testing with ADS not activated using steady-state driving conditions with pass/fail criteria verifying no communication errors, ECU malfunction, freeze, shutdown, or ADS system malfunctions occur, and testing with simulated sensor outputs using data from real-world driving or representative driving scenarios.
Proposal to amend Annexes 11 and 17 to specify an observation time of 2.5 min for quasi-stationary equipment as defined in Table 4 of IEC 61000-3-2, with the equipment operating in the mode expected to produce the maximum total harmonic current under normal operating conditions. Currently, UN R10.07 does not specify an observation time, which may lead to different interpretations of the test method and case-by-case agreement during type approval. Specifying 2.5 min would provide a consistent observation and averaging period for vehicle and ESA type-approval tests without changing existing test conditions, limits, or evaluation method.
Proposal to add a new example and update text based on discussions by the OPI group aimed at finalizing the GID. The revised text adds that the ADS does not transit to a safe state in accordance with the manufacturers defined response as documented in the safety case, and removes provisions regarding the chosen stop location. The group agreed to further work in the next phase on situations where the chosen stop location could have contributed to a collision involving the ADS vehicle before it has moved from that location.
Global Technical Regulation